Recent questions in Analog Electronics

0 0 votes
0 0 answers
All the transistors used in the circuit are matched and have a current gain $\beta$ of $20$. Neglecting the Early effect, the current $I_{O4}$ in milliamphere is ________...
1 1 vote
1 1 answer
Assume that the opamp in the circuit shown is ideal.The value of $\frac{V_x}{I_x} (\text{in k}\Omega)$ is ____________.
0 0 votes
0 0 answers
Assuming that the opamp used in the circuit shown is ideal, the reading of the $1\;Hz$ bandwidth, permanent magnet moving coil $(PMMC)$ type voltmeter $\text{(in volts)}$...
0 0 votes
0 0 answers
If the opamps in the circuit shown are ideal and $V_x=0.5\;mV$, the steady state value of $V_\circ \; \text{(in volts, rounded off to two decimal places)}$ is ___________
0 0 votes
0 0 answers
A circuit consisting of capacitors, DC voltage source and an amplifier having a voltage gain G=-5 is shown in the figure. The effective capacitance across the nodes A and...
0 0 votes
0 0 answers
Assume the diodes in the circuit shown are ideal. The current $I_X$ flowing through the $3\: k\Omega$ resistor $\text{(in mA, rounded off to one decimal place)}$ is _____...
0 0 votes
0 0 answers
If the diodes in the circuit shown are ideal and the breakdown voltage $V_z$ of the Zener diode is $5\;V$ the power dissipated in the $100\;\Omega$ resistor (in watts) is...
0 0 votes
0 0 answers
Assuming ideal opamps, the output voltage at $V_1$ in the figure shown (in volts) is __________
0 0 votes
0 0 answers
Assuming the opamp shown in the figure to be ideal, the frequency at which the magnitude of $V_\circ$ will be $95\%$ of the magnitude of $V_{in}$ is ______________$kHz$.
0 0 votes
0 0 answers
In the circuit, shown in the figure, the MOSFET is operating in the saturation zone. The characteristics of the MOSFET is given by $I_D=\frac{1}{2}(V_{GS}-1)^2$ $mA$, whe...
0 0 votes
0 0 answers
The two-input voltage multiplier, shown in the figure, has a scaling factor of $1$ and produces voltage output. If $V_1=+15\;V$ and $V_2=+3\;V$, the value of $V_\circ$ in...
0 0 votes
0 0 answers
The circuit of a Schmitt trigger is shown in the figure. The zener-diode combination maintains the output between $\pm7\;V$. The width of the hysteresis band is _________...
0 0 votes
0 0 answers
A resistance temperature detector $(RTD)$ is connected to a circuit, as shown in the figure. Assume the opamp to be ideal. If $V_\circ=+2.0$ $V$, then the value of $x$ is...
0 0 votes
0 0 answers
The connection of two 2-port networks is shown in the figure. The $\text{ABCD}$ parameters of $N1$ and $N2$ networks are given as $$\begin{bmatrix}A &B\\C &D\end{bmatrix}...
0 0 votes
0 0 answers
The differential amplifier, shown in the figure, has a differential gain of $A_d=100$ and common mode gain of $A_c=0.1$. If $V_1=5.01\;\text{V}$ and $V_2=5.00\;\text{V}$,...
0 0 votes
0 0 answers
The silicon diode, shown in the figure, has a barrier potential of $0.7\;\text{V}$. There will be no forward current flow through the diode, if $V_{dc}$, in $\text{volt}$...
0 0 votes
0 0 answers
The figure shows a phase locked loop. The output frequency is locked at $f_0=5\;\text{kHz}$. The value of $f_i$ in $\text{kHz}$ is _______________.
0 0 votes
0 0 answers
The condition for oscillation in a feedback oscillator circuit is that at the frequency of oscillation, initially the loop gain is greater than unity while the total phas...
0 0 votes
0 0 answers
The output $\text V_\circ$ shown in the figure, in $\text{volt}$, is close to$-20$$-15$$-5$$0$
0 0 votes
0 0 answers
In the circuit shown below, the input voltage V${_i}{_n}$ is positive. The current (I) – voltage(V) characteristics of the diode can be assumed to be I = I${_0}$e$^{v/vr}...
0 0 votes
0 0 answers
The correct biasing conditions for typical operation of light emitting diodes, photodiodes, Zener diodes are, respectivelyforward bias, reverse bias, reverse biasreverse ...
0 0 votes
0 0 answers
A voltage amplifier is constructed using enhancement mode $MOSFETs$ labeled $M_1,M_2,M_3$ and $M_4$ in the figure below. $M_1,M_2$ and $M_4$ are n-channel MOSFETs and $M_...
0 0 votes
0 0 answers
In the circuit shown below, assume that the comparators are ideal and all components have zero propagation delay. In one period of the input signal $V_{in}=6 \sin(\omega ...
0 0 votes
0 0 answers
In the circuit shown below, all transistors are n-channel enhancement mode MOSFETs. They are identical and are biased to operate in saturation mode. Ignoring channel leng...
0 0 votes
0 0 answers
In the circuit shown below, all OPAMPS are ideal. The current I = 0 A when the resistance R = $\_\_\_\_\_$ k$\Omega$
0 0 votes
0 0 answers
An air cored coil has a $Q$ of $5$ at a frequency of $100$ kHz. The $Q$ of the coil at $20$ kHz (neglecting skin effect) will be ________.
0 0 votes
0 0 answers
The diode $D$ used in the circuit below is ideal. The voltage drop $V_{ab}$ across the $1\;k\Omega$ resistor in $\text{volt}$ is $\_\_\_\_\_\_\_\_.$
0 0 votes
0 0 answers
In the circuit given below, the opamp is ideal. The output voltage $V_o$ in volt is $\_\_\_\_\_\_\_\_.$
0 0 votes
0 0 answers
In the circuit given below, the diodes $D_1$ and $D_2$ have a forward voltage drop of $0.6\;V$. The opamp used is ideal.The $\text{magnitude}$ of the negative peak value ...
0 0 votes
0 0 answers
In the circuit given below, each input terminal of the opamp draws a bias current of $\text{10 nA}$. The effect due to these input bias currents on the output voltage $V_...
0 0 votes
0 0 answers
An ideal opamp is used to realize a difference amplifier circuit given below having a gain of $10$. If $x=0.025$, the $CMRR$ of the circuit in $dB$ is $\_\_\_\_\_\_\_\_$.
0 0 votes
0 0 answers
In the circuit given below, the opamp is ideal. The input $v_x$ is a sinusoid. To ensure $v_y=v_x$, the value of $C_N$ in $\text{picofarad}$ is $\_\_\_\_\_\_\_$.
0 0 votes
0 0 answers
In the circuit given below, the opamp is ideal. The value of current $I_L$ in $\text{microampere}$ is $\_\_\_\_\_\_\_\_.$
0 0 votes
0 0 answers
The bandgap in $eV$ of a semiconductor material required to construct an $LED$ that emits peak power at the wavelength of $620\;nm$ is $\_\_\_\_\_\_\_.$(Plank constant $h...
0 0 votes
0 0 answers
The figure shows a half-wave rectifier circuit with input voltage $V(t)=10\sin(100\;\pi t)$ volts. Assuming ideal diode characteristics with zero forward voltage drop and...
0 0 votes
0 0 answers
A power line is coupled capacitively through various parasitic capacitances to a shielded signal line as shown in the figure. The conductive shield is grounded solidly at...
0 0 votes
0 0 answers
A light detector circuit using an ideal photo-diode is shown in the figure. The sensitivity of the photo-diode is $0.5\:\mu A/\mu W$. With $V_r=6\:V$, the output voltage ...
0 0 votes
0 0 answers
The output frequency of an $LC$ tank oscillator employing a capacitive sensor acting as the capacitor of the tank is $100\;kHz$. If the sensor capacitance increases by $1...
0 0 votes
0 0 answers
In the circuit shown in the figure, it is found that $V_{BE}=0.7\:V$ and $V_E=0\:V$. If $\beta_{dc}=99$ for the transistor, then the value of $R_B$ in kilo ohms is ______...
0 0 votes
0 0 answers
An opamp has ideal characteristics except that its open loop gain is given by the expression $Av(S)=10^4/(1+10^{-3}\;s).$ This op-amp is used in the circuit shown in the ...