Recent questions tagged numerical-answers

The differential pressure transmitter of a flow meter using a venturi tube reads $2.5\times 10^5\;Pa$ for a flow rate of $0.5\;m^3/s$. The approximate flow rate in $m^3/s...

A band-limited signal with a maximum frequency of $5\;kHz$ is to be sampled. According to the sampling theorem, the sampling frequency in $kHz$ which is not valid is$5$$1...

The transfer function $\frac{V_2(s)}{V_1(s)}$ of the circuit shown below is $\frac{0.5s+1}{s+1}$$\frac{3s+6}{s+2}$$\frac{s+2}{s+1}$$\frac{s+1}{s+2}$

Assuming zero initial condition, the response $y(t)$ of the system given below to a unit step input $u(t)$ is$u(t)$$t u(t)$$\frac{t^2}{2}u(t)$$e^{-t}u(t)$

The Operational amplifier shown in the circuit below has a slew rate of $0.8\; Volts/\mu s$. The input signal is $0.25\; \sin (\omega t).$ The maximum frequency of input ...

A source $v_s(t)=V\cos 100 \pi t$ has an internal impedance of $4+j3\; \Omega$. If a purely resistive load connected to this source has to extract the maximum power out o...

In the transistor circuit as shown below, the value of resistance $R_E$ in $k\Omega$ is approximately, $1.0$$1.5$$2.0$$2.5$

For a periodic signal $v(t)=30\sin 100t+10\cos 300t+6\sin (500t+\frac{\pi}{4})$, the fundamental frequency in $rad/s$ is $100$$300$$500$$1500$

The complex function $\tan h(s)$ is analytic over a region of the imaginary axis of the complex s-plane if the following is $\text{TRUE}$ everywhere in the region for all...

With $\text{10 V}$ dc connected at port $\text{A}$ in the linear nonreciprocal two-port network shown below, the following were observed:$\text1\;\Omega$ connected at por...

The deflection profile $y(x)$ of a cantilever beam due to application of a point force $F$ (in Newton), as a function of distance $x$ from its base, is given by $y(x)=0.0...

The deflection profile $y(x)$ of a cantilever beam due to application of a point force $F$ (in Newton), as a function of distance $x$ from its base, is given by $y(x)=0.0...

The transfer function of a compensator is given as $$G_c(s)=\frac{s+a}{s+b}$$The phase of the above lead compensator is maximum at $\sqrt{2}\;\text{rad/s}$$\sqrt{3}\;\tex...

The power factor of the load is$0.45$$0.50$$0.55$$0.60$

If $R_L=5\;\Omega,$ the approximate power consumption in the load is $700\;\text{W}$$750\;\text{W}$$800\;\text{W}$$850\;\text{W}$

A dynamometer arm makes contact with the piezoelectric load cell as shown. The $g-$constant of the piezoelectric material is $50\times10^{-3}\;\text {Vm/N}$ and the surf...

The open loop transfer function of a unity negative feedback control system is given by $G(s)=\frac{150}{s(s+9)(s+25)}$. The gain margin of the system is $10.8\;\text{dB}...

An analog voltmeter uses external multiplier settings. With a multiplier setting of $20\;\text{k}\Omega$, it reads $400\;\text{V}$ and with a multiplier setting of $80\;\...

Water $\text{(density:}\;1000\;\text{kgm}^{-3})$ stored in a cylindrical drum of diameter $1\;\text{m}$ is emptied through a horizontal pipe of diameter $0.05\;\text{m}$....

The double convex lens is used to couple a laser beam of diameter $5\;\text{mm}$ into an optical fiber with a numerical aperture of $0.5$. The minimum focal length of the...

The open loop transfer function of a unity gain negative feedback control system is given by $G(s)=\frac{s^2+4s+8}{s(s+2)(s+8)}.$ The angle $\theta$ , at which the root l...

With $\text{10 V}$ dc connected at port $\text{A}$ in the linear nonreciprocal two-port network shown below, the following were observed:$\text1\;\Omega$ connected at por...

The state variable description of an $\text{LTI}$ system is given by $$\begin{bmatrix}\dot{x_1}\\\dot{x_2\\\dot{x_3}}\end{bmatrix}=\begin{bmatrix}0 & a_1 & 0\\0 & 0 & a_2...

The circuit shown is alow pass filter with $\text{f}_{3\text{dB}}=\frac{1}{(R_1+R_2)C}\;\text{rad/s}$high pass filter with $\text{f}_{3\text{dB}}=\frac{1}{R_1C}\;\text{ra...

The feedback system shown below oscillates at $2\;\text{rad/s}$ when$K=2$ and $a=0.75$$K=3$ and $a=0.75$$K=4$ and $a=0.5$$K=2$ and $a=0.5$

Let $y[n]$ denote the convolution of $h[n]$ and $g[n]$, where $h[n]=(1/2)^n\;u[n]$ and $g[n]$ is a causal sequence. If $y[0]=1$ and $y =1/2$, then $g $ equals$0$$1/2$$1$$...

Consider the differential equation$\frac{d^2y(t)}{dt^2}+2\frac{dy(t)}{dt}+y(t)=\delta(t)$ with $y(t)|_{t=0^-}=-2$ and $\frac{dy}{dt}|_{t=0^-}=0$.The numerical value of $\...

The voltage gain $A_v$ of the circuit shown below is$|A_v|\approx 200$$|A_v|\approx 100$$|A_v|\approx 20$$|A_v|\approx 10$

Assuming both the voltage sources are in phase, the value of $\text{R}$ for which maximum power transferred from circuit $\text{A}$ to circuit $\text{B}$ is $0.8\;\Omega$...

If $\text{V}_\text{A}-\text{V}_\text{B}=6\;\text{V}$, then $\text{V}_\text{C}-\text{V}_\text{D}$ is $-5\;\text{V}$$2\;\text{V}$$3\;\text{V}$$6\;\text{V}$

For the circuit shown in the figure, the voltage and current expressions are $v(t)=E_1\sin(\omega t)+E_3\sin(3\omega t)$ and $i(t)=I_1\sin(\omega t-\phi_1)+I_3\sin(3\omeg...

A periodic voltage waveform observed on an oscilloscope across a load is shown. A permanent magnet moving coil $\text{(PMMC)}$ meter connected across the same load reads$...

The responsivity of the $\text{PIN}$ photodiode shown is $0.9\;A/W.$ To obtain $V_\text{out}$ of $-1\;\text{V}$ for an in optical power of $1\;\text{mW},$ the value of $R...

Light of wavelength $630\;\text{nm}$ in vacuum, falling normally on a biological specimen of thickness $10\;\mu\text{m}$, splits into two beams that are polarized at righ...

An $\text{LED}$ emitting at $1\;\mu\text{m}$ with a spectral width of $50\;\text{nm}$ is used in a Michelson interferometer. To obtain a sustained interference, the maxim...

A strain gauge is attached on a cantilever beam as shown. If the base of the cantilever vibrates according to the equation $x(t)=\sin\omega_1t+\sin\omega_2t,$ where $2\;\...

A capacitive motion transducer circuit is shown. The gap $d$ between the parallel plates of the capacitoes is varied as $d(t)=10^{-3}[1+0.1\sin(1000\pi t)]\;\text{m}.$ If...

The $i-v$ characteristics of the diode in the circuit given below are $$i=\left\{ \begin{array}{rcl} \frac{\text{v}-0.7}{500}\text{A},& \text{v}\geq0.7\text{v}\\ 0\;\text...

In the circuit shown below, the current through the inductor is $\frac{2}{1+j}\text{A}$$\frac{-1}{1+j}\text{A}$$\frac{1}{1+j}\text{A}$$0\text{A}$

The average power delivered to an impedance $(4-j3)\Omega$ by a current $5\cos(100\pi t+100)\text{A}$ is $44.2\;\text{W}$ $50\;\text{W}$ $62.5\;\text{W}$ $125\;\text{W}$